NEW
The Micro Drill Adaptor is like a miniature quill and is designed for drilling small holes using a lathe, mill or pillar drill.
(Chuck not included)
A complete set of all the Indexing Tailstock Turret parts shown below, i.e. Turret, Live Centre, Tapping Collet Set, Die Holder Set and 3 Drill Chuck Arbors (JT0, JT1 and JT2).
(Excludes Blank End Arbor and ER11 Collet Chuck)
Choice of MT2 or MT3
A really useful tool for any repetition work that requires the use of more than 1 tool in the tailstock. The head has 6 indexable stations into which you can fit drill chucks, tap & die holders, live centres etc.
Tailstock Fitting: MT2 or MT3
Socket Size: 16mm
See below for suitable accessories.
Suitable for our Indexing Tailstock Turret.
Spigot Size: 16mm
The 2 part main body fits our Indexing Tailstock Turret and is free to slide back and forth allowing the tailstock to locked in place during tapping operations.
A set of 7 Tap Holders in various sizes fit into the end of the main body.
Note: If you can't find a tap holder with the right diameter bore and square to suit your tap, one could easily be modified by boring to the correct diameter and fitting 2 grub screws (at 90° to each other) to hold the square end of your tap.
Free Movement: 35mm
The 2 part main body fits our Indexing Tailstock Turret and is free to slide back and forth allowing the tailstock to locked in place during threading operations.
A set of 5 Die Holders in various sizes fit into the end of the main body.
Die Holder Sizes: 20mm (2 off), 25mm, 30mm, 35mm
Note: The die holders are for metric size dies but could easily be turned to fit Imperial diameter dies if required.
JT0 Drill Chuck Arbor to fit our Indexing Tailstock Turret.
JT1 Drill Chuck Arbor to fit our Indexing Tailstock Turret.
JT2 Drill Chuck Arbor to fit our Indexing Tailstock Turret.
Blank End Arbor to fit our Indexing Tailstock Turret. The soft "blank end" can be turned, milled, drilled, tapped etc to suit whatever application you can think of, e.g. one size drill holder, centre drill holder, tap holder, etc. etc.
Diameter: 20mm
Length: 35mm
Highly accurate small size collet chuck
Designed to fit either a Jacobs JT1 taper spindle OR our Tailstock Turret system by virtue of the 16mm O.D. Body
For holding small round parts in a tailstock for cross drilling. Will hold round bar up to ø15mm as supplied or ø24mm with longer clamping bolts fitted (not supplied).
Clamping plate included.
Used to support small diameter work at the tailstock where a live centre is not practical Complete with 13mm drill chuck
Arbor Length = 55.5mm (self-ejects from C3 tailstock but may not self-eject from tailstocks on other lathes - please check before jamming it in too tight!)
Used to support small diameter work at the tailstock where a live centre is not practical Complete with 13mm Keyless drill chuck
Supplied without chuck
Designed for use in the tailstock with our 60mm 3 jaw chuck and 2.5" slim body 4 jaw chuck.